Unit Manager- Edit Design Criteria

Select the Unit Type to edit in the list box as shown above.
Click Edit Design Criteria to open edit dialog box

Edit Unit Type Data Unit Type Name: Enter a unique identifier for this Unit Type. Changing this value will create a new Unit Type.  Leaving this value unchanged will overwrite the existing Unit Type. Unit Description:Description of this Unit Type Lot Dimensions Width: Nominal Width of this Unit Type.  This is the width that controls how Units are drawn.  This width will be maintained at the critical position (see Create Lot Lines for further explanation) Minimum Area: The nominal area of the Unit.  When units are drawn, if the Width and Depth are not sufficient to create the Minimum area, the width will be adjusted until Minimum Area requirements are met. Depth: This is the nomimal depth of the unit (Minumum Area / Width) Setbacks Front:  Front Setback as measured from front property line. Standard Side: Side Setback as measured from side property line. Corner Side: Total width of Corner Setback for lots that front on two streets. Rear: Rear Setback as measured from the rear property line. Building Envelope Width: This is usually the Unit Width - 2 * Standard Side Setback.  Depth: The depth of the house as measured from the front setback.  This dimension added to the front setback is the depth at which Unit width is calculated to determine the . critical position (see Create Lot Lines for further explanation

Easement Settings Width : The width of the easment. Easement Separation: A distance in feet between each easement. Adjust Lot Width for Easement : Check this box if the width of the lot should be adjusted to allow for intrusion of the easement into the buildable area of the lot. Lot Width Adjustment: The distance in feet that needs to be added to those lots on which easements fall to adjust for any intrusion of the easement into the buildable area of the lots.   Validate Input: Clicking this button will check all input for valid values.  Any invalid values will be flagged and the user will be prompted to change them. Clicking this button will also enable the OK button OK:  Click this button to save the changes to this Unit Type. Cancel: Click this button to close the dialog box without saving the changes.     Help: Click this button to display this Help File.