This function allows a user to layout lots starting from an existing lot line, open space or other situation
where standard side setbacks are required. The first lot created will have standard side setbacks.

The user is prompted to select a Base Entity. This should be a lightweight polyline.  If other entity
types are selected, the user will be alerted and the function will exit.

After selecting the base entity, the function prompts for the side of that entity on which to draw the lots.
The user can enter "L" or "R" (Left and right are based on standing on the entity and looking up station, from
station 0+00 toward station 1+00.  Temporary directional arrows will indicate which direction the entity was
drawn).  Or the user can simply indicate the desired side with a mouse click.

The user will then be prompted to select the type of units to be drawn.

If no Unit Types are present in the drawing, the user will be alerted and the function will exit.  Unit Types must then
be created or imported before the function can be used.

After selected the desired unit type, the function will ask for the desired Starting Station.  The value can be entered
(stations should be entered without the plus sign, Station 1+15.25 would be entered 115.25). Or the user can
indicate the starting station with a mouse pick.  The point picked does not have to be directly on the base entity.
The first lotline will be drawn at the station nearest point picked.

The user will then be prompted for the ending station. This value, like the starting station, can be entered directly
or indicating on the screen.  The function will compute full-size and stop drawing lots as near as possible to the
indicated ending station.  The last lot line may not be drawn at the indicated ending station depending on the
mathematics of the stations, lot size, and base entity geometry. 

Please note that Land Planner Suite will draw lots in any direction.  The direction in which the base entity
was drawn has no impact on the way lots are computed.  Lots can be drawn up-station or down-station.

The user will then be asked if lot widths should be adjusted to allow for easements.  The user can answer "Y" or "N".
Answering Yes will cause the function to draw easements at the separation distance indicated in the Unit Design Criteria
If the distance entered in the Unit Design Criteria is not an even multiple of the nomimal lot width, the user will be prompted
for the numbers of lots to draw before drawing an easement.  (Please see Unit Design Criteria in this manual for additional
information on the easement calculations.)

.